hitron electronics corporation. b4-11, p.o. box 26-110 kaohsiung export processing zone kaohsiung 806 taiwan tel: 886-7-8210410/fax: 886-7-8419917, 886-7-8210511/e-mail: sale s@hitron-e.com/web-site: www.hitron-e.com edited on march 13, 2013 -1- h hitron universal ac input harmonic correction ac-dc hot-swap compactpci serial single output with standby 312 watts active current sharing switching power supplies HAC300S series features: ? 312w 3u x 8hp eurocard package ? wide operating temperature range of -40c to +70 c ? meet iec 61000-3-2 harmonic correction ? n+1 redundancy/hot-swappable ? 80 plus gold efficiency ? active current sharing ? pmbus communication ? fully compliant with picmg specification input specification input voltage: typ. 90-264vac. power factor correction: meet harmonic correction iec 61000-3-2.power factor typ. 0.98-0.99. input connector: fci 51939-667lf. input frequency: 47-63hz. inrush current: 5.3arms at 230vac. input current: 3a at 115vac/1.5a at 230vac. dielectric withstand: meet iec 60950-1 regulation. emi: meet en 55022 / fcc class b. hold-up time: 18ms at 115 & 230vac. leakage current: less than 0.7ma at 230vac. power fail signal: available at [fal#] pin. remote on/off: available. status led: means valid input voltage. means a critical fault. means dc ok. thermal protection (otp): installed ntc and thermostat for thermal sensor at [deg#] pin. output specification output voltage: see ratings chart. output current: see ratings chart. output wattage: typ. 312w continuous. output connector: fci 51939-667lf. line regulation: typ. 1%. load regulation: vo1 typ. 1%./ standby typ. 5% noise & ripple: typ. 1% peak to peak. ovp: built-in at all outputs. adjustability: available for vo1. remote sensing: available for vo1. dc ok: available for vo1 & +5vsb. hot-swap: available. n+1 redundancy: installed with internal or-ing diodes at all outputs for n+1 redundancy operation. current sharing: active current sharing at vo1. overload protection (olp): fully protected against output overload or short circuit. olp set at 120-130% peak current at 115vac. consult the factory for special olp setting. general specification efficiency: typ. 90% at 230vac. switching frequency: 85-100k hz. circuit topology: llc circuit. transient response: peak transient less than 134mv and recovers within 0.5ms after 25% load-change. safety standard: iec 60950-1 class i. construction: 3u x 8hp compactpci format. front panel with extractor handle. operating temperature: -40 c to +70 c (see note 3) , derate linearly from 100% power at +50 c to 60% power at +70 c (refer to derating curve). storage temperature: -45 to +85 c. cooling: at least 200 lfm moving air is required to achieve full rating power 312w in a confined area. power density: 5.7 watts/ cubic inch. note: (1)all measurement are at nominal input, full load and +25c unless otherwise specifications. (2)due to requests in market and advances in technology , specifications subject to change without notification. (3)a warm-up time 10 minutes is required after co ld start at temperature from -40 c to +0c. (4)tantalum capacitors connected to system is suggested for bettering ripple & noise against operating temperature from -40c t o +0c.
hitron electronics corporation. b4-11, p.o. box 26-110 kaohsiung export processing zone kaohsiung 806 taiwan tel: 886-7-8210410/fax: 886-7-8419917, 886-7-8210511/e-mail: sale s@hitron-e.com/web-site: www.hitron-e.com edited on march 13, 2013 -2- output voltage / current ratings chart mechanical dimensions: mm [inches] weight: 710 g (25.1 oz.) quad output main vo1 @ standby vo2 model no. min. typ. volt. max. peak min. typ. volt. max. peak HAC300S-d120e 0a 25.0a 12v 25.0a 28.0a 0a 2.5a 5v 2.5a 3.0a symbol: " " ovp built-in. "@" adjustable . "#" remote sensing. " " active load sharing. ." " installed with or-ing diode. remark: 1.peak load less than 60s ec. with duty cycle <10%. 2.max. load is the continuous operating load of each rail. but the max. load of each rail can't be drawn from all outputs at th e same time. 3.please consult the factory if you have the special min load request of vo1. input & output connectors pin assignment p1 p2 p3 p4 p5 d1 d2 d3 d4 d5 d6 p6 p7 p8 p9 n/a fal ps_p com deg 5vsb c1 c2 c3 c4 c5 c6 n/a n/a com a0 alert 5vsb b1 b2 b3 b4 b5 b6 n/a 12vcs pson a1 scl com a1 a2 a3 a4 a5 a6 line neutral gnd n/a n.a n/a -vs +vs a2 sda en com com vo1 +12v vo1 +12v remark: mating connector fci 51940-350lf derating curve
|